Take Good Care of your DA6100B-Notes Just For You

Engineer Manager:

MS. Melin,

WhatsApp:+86-18291418396,

If a customer receives our 6100B, how to maintain it so that it can be used for as long as it should be used? The following are suggestions for you, please refer to it. I wish you have a good time when using 6100B.

1. Optical lens

The front side of the lens is coated with a film. When using it, you need to be careful and to clean it regularly to prevent it from being stained by corrosive liquid or oil contamination. After using the equipment, the lens cover should be put on in time to avoid dust and any damage. When cleaning is required, please use flannel or alcohol cotton balls to clean.

Do not wipe it with your hands or other objects to avoid scratching the lens, thus affecting the quality of image.

When cleaning the eyepiece lens, please use a flannel cloth or alcohol cotton ball to clean it. Do not use your hands or other objects to avoid scratching the lens, thus affecting the quality of image.

DA-6100B

2. Body Part

After using, use a clean brush or soft cloth to wipe the body part clean, to remove water droplets or any other contamination.And then place the body part into the carrying case.

3. Storage and transportation

After using, the body part and accessories should be placed in the carrying case in time. The storage environment should be dry and ventilate, avoid direct sunlight, and keep away from high temperature sources. During the moving and transportation process of the device,

Severe shock and vibration should be avoided, otherwise it may cause damage to structural parts of the device or reduce optical performance.

4. Battery maintenance

To avoid injury and operate the device safely:

• Do not place batteries and battery packs near sources of heat or fire. Do not expose to sunlight.

• Do not disassemble or squeeze batteries and battery packs.

• If the device is not used for a long time, please remove the battery to prevent battery leakage and related damage to the device.

• Please use a power adapter approved by the equipment manufacturer to charge the battery.

• Keep batteries and battery packs clean and dry. Clean the connector with a dry, clean cloth.

To avoid damage:

• Do not charge the battery for over 24 hours, otherwise the working time of the battery may be shortened.

•Charge the device for at least two hours every six months to maximize the working time of the battery. If not using, the battery will self-discharge after approximately six months. Batteries for long term storage

• It takes between two and ten charging cycles to reach maximum capacity for a battery that is intended to be stored for a really long time.

• Please use it within the system operating temperature range. Do not burn this device and battery.

That is all for today’s introduction. If you have any questions, please feel free to contact us. Hope you have a nice day! See all of you next time!

Engineer Manager:

MS. Melin,

WhatsApp:+86-18291418396,

Email: melin@ireeda.com